Log in

Sangfor Support Center

Table of Contents
< All Topics
Print

[Hardware troubleshooting] SN Install two M10 Graphics Card for F6N and FBN Services and could not enter System processing

Posted
Updated
Byadmin
Views2

Problem Description

Phenomenon:
Connect the monitor to View the device Auto unlock after hardware quality inspection interface. The quality inspection code in the lower right corner is 94. The powerRestart phenomenon is Mon same, and the quality inspection cannot be Skip.

solution

Remove Mon M10 Graphics Card or replace it with Other supported Graphics Card. If the Test Connectivity device must use two M10 Graphics Card, use a GPU server with SN starting with 9T, F6T, 9E, or F6E.

Cause:
When the manufacturer Import GPU Model, the M10 had been discontinued and no adaptation was done. The M10 Graphics Card has 4 GPU chips and the required BIOS Resource Allocate and different from Other cards. The manufacturer replied that this Graphics Card is not supported and if it is to be used, only Mon M10 Graphics Card can Install.

Original Link

https://support.sangfor.com.cn/cases/list?product_id=156&type=1&category_id=22678&isOpen=true