[aCloud] When adding an aggregated Aggregate Interface, some network ports cannot be selected

Problem Description

It is necessary to deploy an Aggregate Interface in the hyper-convergence, but it is found in the physical network configuration that some network ports cannot be selected as Aggregate Interface. For example, when eth1 and eth2 need to be aggregated, eth3 port cannot be selected.

523885b48352732422.png (13.8 KB)

Solution

Check whether the network port that cannot be selected has been used for other purposes, such as being bridged by the physical Physical Interface in the Virtual Network and being used as a Overlay Network Interface, storage port, etc. If there are any, you can temporarily replace these ports that are used for other purposes with other network ports, and then make them into aggregate interface

Original Link

https://support.sangfor.com.cn/cases/list?product_id=33&type=1&category_id=15468&isOpen=true